cat ~/.kermrc
set modem type none ; There is no modem
set line /dev/ttyS0 ; Specify device name
set carrier-watch off ; If DTR CD are not cross‐connected
set speed 115200 ; Or other desired speed
set flow rts/cts ; If RTS and CTS are cross‐connected
; the following equivalent to kermit -8
set terminal bytesize 8
set command bytesize 8
set parity none ; (or "mark" or "space", if necessary)
set stop-bits 1 ; (rarely necessary)
set flow xon/xoff ; If you can't use RTS/CTS
connect ; Enter Connect (terminal) state
如果是要存取 gsm/gprs modem 的話，也可以試
set modem type user ; User defined
set modem name my-gsm ; gsm/gprs modem with AT commands
set modem capabilities at
set modem carrier-watch off
set modem kermit-spoof off
set modem flow-control none
set input echo on
set line /dev/ttyS0 ; Specify device name
set carrier-watch off ; If DTR CD are not cross connected
set speed 115200 ; Or other desired speed
; the following equivalent to kermit -8
set terminal bytesize 8
set command bytesize 8
set parity none ; (or "mark" or "space", if necessary)
set stop-bits 1 ; (rarely necessary)
set flow none
set local-echo on
; output AT\13 ; modem expect carriage return (13 in decimal or 0xD in hex)
lineout AT ; lineout would add carriage return for you
connect ; Enter Connect (terminal) state, you should see AT response OK
最後 sudo kermit 就可以 access
另外在 windows 上也可以用 putty 連線到 serial port, 選 serial 設定 baud rate 就可以 connect, 比一些 dummy terminal 好用一點, 至少有 copy/paste 可以用 :P
要 cross compile ckermit 時，需要先 build host 版本的 wuart, 把 wuart 保留一份 host build 的版本，在 cross compile target 中 failed 時手動換回 host 版本 wuart，再繼續 build 出 wermit, 要自己 rename 為 kermit :P
